Drive Train Failure

Location
Various
Fault
2 x Flexi plates and GB flange/hub broken
Sensors Used to Detect Fault
Vibration
Customer
Various
Savings
£25,000 - £30,000
Detection
Progressed over a month

M-HAS alarmed at a site in July 2020. The system started to detect a fault developing around the start of June 2020 alarming on high vibration on the gearbox initially then shaft and frame.
The machine was stopped and the drive train scheduled for parts replacement and alignment adjustments made below. The system then reduced vibration levels.
This would have progressed to a very expensive set of replacement parts requiring a machine shop repair versus a simple up tower adjustment and parts replacement
Therefore the full cost of repair would have been significantly higher had these failures not been caught.
Learn More About M-HAS
For more information on the system and learn more on how you can benefit form M-HAS
